Jabsco 18590-2092 Marine Run-Dry Heavy Duty Macerator Waste Pump (12-Volt)

Jabsco Run - Dry Macerator 12V Waste Pump... clog - crushing blade makes emptying easy! Has a triple-sealed motor and powerful macerator to chop up holding tank waste! Has the Run-Dry feature to provide adequate run-dry period to allow initial priming. Crank out waste: 12V motor is fully sealed and consists of o-ring sealed endbells, sealed bearings and a hard, durable powder coating for corrosion resistance; Detects the absence of fluid, then shuts off pump before impeller is damaged; Interrupting power supply to macerator resets the run-dry device; Flow rate moves at up to 12 gallons per minute; Self-priming to 4 ft. vertical lift; Complies with USCG 183.410 and ISO 8846 Marine (Ignition protection); Inlet port is 1 1/2" plus 1 1/2" NPT; Order this powerful Pump! Jabsco Run-Dry 12V Macerator Waste Pump

The Jabsco 18590 series DC macerator waste pump is the ideal solution for boaters who need to empty marine holding tanks when not in a discharge-restricted area. Self-priming to 5 feet, the pump will empty a typical 30-gallon (115-liter) holding tank in less than three minutes. The pump's duty cycle, meanwhile, is 15 continuous minutes, which means you can empty a 180-gallon (680-liter) pump in a single operation. The macerator pump is also a good choice when emptying fish box and livewell receptacles. Specific features include a Jabsco Nitrile compound impeller, a stainless-steel cutter that reduces the particle size to 1/8 inch maximum, and a lip type seal.

Specifications:

• Pump: Self-priming flexible impeller with stainless-steel wearplate
• Inlet port: 1-1/2-inch (38mm) hose barb and 1-1/2-inch N.P.T. (male)
• Outlet port: 1-inch hose barb
• Motor: Permanent magnet type, fully enclosed, with stainless-steel shaft; includes run-dry protection device that shuts off pump
• Voltage: 12 EMC
• Amp draw: 16 amps
• Fuse rating: 20 amps
• Weight: 5 pounds